VAT 612 Series - Page 102

MAINTENANCE Series
612
102/116 Edition 2018-08-20 605262EE
Description
Required tool
5. Remove the panel
6. Remove the master board or replace
it, if existing master board is defect
7. Remove the interface board or replace
it, if existing interface board is defect
8. Remove the option board or replace it,
if existing option board is defect
9. Insert all boards in reverse order as
they disassembled at correct
positions (see steps 8…6)
10. Reassemble the controller panel
(see steps 5…3).
Open end wrench 10mm
11. Tighten female screw locks from
POWER and SENSOR connectors
with 1.1 Nm
(see step 2)
Open end wrench 4.5 mm