174 Vehicle care
5. Remove and renew the bulb.
Reverse light/brake light (1)
Reverse light (2)
Fog light, may be only on one side
(3)
Reverse light (4)
Turn signal light (5)
6. Insert bulb holder in bulb housing
by first inserting the lug at the front
of the plug. Fold together bulb
holder, ensuring that it engages
properly. Insert sockets and
engage by turning.
7. Fit seal on bulb holder. Ensure
that the seal is flat in the area of
the screws.
8. Engage plug. Insert bulb housing
in body, ensuring proper
positioning of the ball pins in the
recesses. Tighten the retaining
nuts.
Side turn signal lights
Have the bulbs replaced by
a workshop.
Number plate light
1. Insert a screwdriver in the
housing, press to the side and
release spring.
To Next Page
Loading...
