Driving and operating 123
If the battery is not the cause of the
fault, release the selector lever.
1. Turn the ignition off and remove
the key.
2. Depress and hold the brake pedal
and pull the parking brake lever
up.
3. Remove the cap on the console
with a thin object such as a
screwdriver.
4. Insert a screwdriver into the
opening as far as it will go.
5. Shift selector lever to N.
6. Remove the screwdriver from the
slot.
7. Reinstall the cap.
8. Have the cause of the power
supply interruption remedied by a
workshop.
Manual transmission
To engage reverse, with the vehicle
stationary wait 3 seconds after
depressing the clutch pedal and then
press the release button on the
selector lever and engage the gear.
If the gear does not engage, set the
lever to neutral, release the clutch
pedal and depress again; then repeat
gear selection.
Do not grind the clutch unnecessarily.
When operating, depress the clutch
pedal completely. Do not use the
pedal as a foot rest.
To Next Page
Loading...
