Vehicle care 239
4. Set the jack to the necessary
height. Position it directly below
the jacking point in a manner that
prevents it from slipping.
Ensure that the edge of the body
fits into the notch of the jack.
With the jack correctly aligned
jack up until wheel is clear of the
ground.
5. Unscrew the wheel nuts.
6. Change the wheel.
7. Screw on the wheel nuts.
8. Lower the vehicle and remove
jack.
9. Install the wheel wrench ensuring
that it is located securely and
tighten each bolt in a crosswise
sequence.
Tightening torque is 115 Nm.
10. Stow the replaced wheel, the
vehicle tools and the adapter for
the locking wheel nuts 3 227.
11. Check the tyre pressure of the
installed tyre and the wheel bolt
torque as soon as possible.
Stowing a damaged full size
wheel in the load compartment
The spare wheel well is not designed
for other tyre sizes than the spare
wheel. A damaged full size wheel
must be stowed in the load
compartment and secured properly.
Loading information 3 63.
To Next Page
Loading...
