150 Self-help, vehicle care
Tail lights
1. Disengage cover by pressing retaining
lugs and remove.
2. Deta ch plug connector from bulb
mounting.
3. Grip the bulb housing from the outside,
slacken the two knurled nuts using the
wheel bolt spanner 3 and unscrew by
hand.
4. Deta ch bulb housing.
5. Press retaining lugs on bulb mounting
together and remove bulb m ounting, as
shown in Fig. 13726 S.
Lights from top to bottom:
6. Remove bulb from socket.
7. Insert a new bulb. Engage the bulb
mounting in the bulb housing. Insert the
bulb housing into the vehicle b od y.
Screw the fixing nuts onto setscrews by
ha nd and tighten. Engage the plug
connector. Place the cover in position
and close.
Reversing light/brake light
Turn signal lig ht
Reversing light
Fog tail light (country-specific version:
fog tail light a t one side only).
Ofrecido por www.electromanuales.com
To Next Page
Loading...
