115Lighting
Door-to-door lighting
The dipped beam remains switched on for
approx. 30 seconds once you have left the
vehicle and closed the driver’s door.
To activate
1. Switch off ignition.
2. Remove ignition key.
3. Open driver’s door.
4. Pull turn signal stalk towards steering
wheel.
5. Close driver’s door.
If the driver’s door is left open, the lights will
extinguish after two minutes.
The light is switched off immediately by
inserting the key into the ignition or pulling
the turn signal stalk towards the steering
wheel again.
Switching on the exterior lighting
with the remote control 3
The lead-me-to-the-vehicle light function
switches the dipped beam on for approx.
30 seconds.
Programme function
This function can be activated and
deactivated depending on the key used -
see "Personalised key" on pages 40, 42
(P1).
To activate
Press button q on the remote control twice
when the vehicle is locked.
Country-specific application 3: To switch
on the lead-me-to-the-vehicle light
function, press button q on the remote
control once the vehicle is locked.
Switching on the ignition or pressing
button p on the remote control will
deactivate the lead-me-to-the-vehicle light
function early.
Ofrecido por www.electromanuales.com
To Next Page
Loading...
