Vehicle care 163
5. Gently press the three locking
lugs on the outside of the bulb
holder outwards and remove bulb
holder.
6. Push bulb into socket slightly,
rotate anti-clockwise, remove and
renew bulb.
Reverse light (right side), rear fog
light (left side) (1)
Tail light (2)
Turn signal light (3)
Tail light/brake light (4)
Tail light (5)
7. Engage bulb holder in bulb
housing, ensuring that it properly
engages.
8. Ensure that the bulb holder seal is
positioned as illustrated. Fit the
round seal on the fastening bolt.
9. Insert bulb housing in vehicle
body, and tighten securing nuts by
hand. Engage plug connector.
Close and lock cover.
After bulb replacement, check the tail
lights for proper functionality: switch
on the ignition, operate the brake,
switch on the sidelights.
Side turn signal lights
To replace bulb, remove lamp
housing:
1. On left vehicle side, slide lamp to
the front and remove it out of the
front wing with the rear end.
On right vehicle side, slide lamp to
the rear and remove it out of the
front wing with the front end.
To Next Page
Loading...
