20 5
Ellipsoidal headlight system,
dipped beam
Headlight system with sep arate bulbs for
dipped beam (inner bulb s) and m ain beam
(outer bulbs).
1. Open bonnet and engage supp ort.
2. When replacing bulb s on the left-hand
side, open the cover of the fuse box.
When replacing bulbs on the right-hand
side, detach the air hose from the a ir
filter. Lift off the filler neck of the
headlight wash reservoir 3.
3. Remove the headlight protective cover
by pressing the catch and pulling the
cover downward and off.
4. Detach plug connector from bulb.
5. Disengag e the spring wire clip from the
lugs and swivel it aside.
6. Remove bulb from reflector housing.
7. When fitting a new bulb, engage the
lugs in the recesses on the reflector
without touc hing the glass.
8. Engage spring wire clip, plug connector
onto bulb.
9. Place headlight protec tive cover in
position and close.
10. After replacing bulbs on the left-hand
sid e, close the cover of the fuse box.
After replac ing bulbs on the right-hand
sid e, reattach the air hose to the air
filter. Refit the filler neck of the
headlight w ash reservoir 3.
To Next Page
Loading...
