67
– or –
slot the latch plates of the seat belts in
the holders in the side trim cover – see
Fig. 11585 S on previous pa ge.
Removing rear head restraints 3 – push
detent springs to release – see page 65.
Remove the push-in sleeves for mounting
the ISO-FIX child restraint system – see the
separate instructions for the ISO-FIX child
restraint system.
Raise front edge of single-piece ba ckrest or
split backrest 3 and tilt forward.
Unlock the single-piece rear seat backrest
or split re ar se at bac kres ts 3 by pulling on
the handles and tilt it/them forwards.
Repositioning the rear seats
When repositioning the bac krest, pull the
seat belts forw ard slightly. Audibly engag e
the backrest in the intermediate or end
position. There is a loc k indicator 3 on the
handles. If the bac krest is properly
eng aged, the red field 3 will not be visible
on the handle.
Fold the rear seat d ow n and push it into
place between the backrest and the vehicle
floor. Press on the front edge of the rear
seat to lock it audibly into p la ce.
Refit the hea d restraints 3.
The three-point seat belt on the centre
rear seat can only be pulled out of the
retractor 3 if the rear seat b ackrest is
eng aged.
To Next Page
Loading...
