64 Instruments and controls
Engine coolant temperature
gauge
Midlevel instrument cluster
Uplevel instrument cluster
Displays the coolant temperature.
The red zone indicates that the
operating temperature of the engine
is too high.
Control indicator 2 or V illuminates
red if coolant temperature is too high.
Caution
If engine coolant temperature is
too high, stop vehicle, switch off
engine. Danger to engine. Check
coolant level.
Engine oil level monitor
The state of the engine oil level is
displayed in the Driver Information
Centre for a few seconds following
the service information after switching
on the ignition.
A proper state of engine oil level is
indicated by a message.
If engine oil level is low, T flashes
and a message is indicated,
accompanied by the C indicator.
Confirm engine oil level by using the
dipstick and top up engine oil
respectively.
Engine oil 3 260.
A fault of measurement is indicated
by a message. Check engine oil level
manually by using the dipstick.
Service display
The service system informs when to
change the engine oil and filter or a
vehicle service is required. Based on
driving conditions, the interval at
which an engine oil and filter change
are required can vary considerably.
Service information 3 293.
To Next Page
Loading...
