9
V
ax Careline 0870 606 1248
maintenance
Let go of trigger and pull tool over same area to pick up
dirty solution without putting down more solution.
Continue using dry strokes until you see only a little
solution coming up through the tool.
Do not make the upholstery too wet! Use no more than
two strokes while releasing solution. Always follow with
dry strokes - the more the better.
Listen carefully! When the motor sound changes (rises in
pitch), the recovery tank need to be emptied. When water
has reached the full line in the recovery tank, the cleaner
will NOT pick up dirty solution.
Allow upholstery to dry. Avoid using upholstery until it is
dry. Increased air circulation (open doors, turn on fans,
etc.) will help upholstery dry thoroughly to prevent the
growth of mold or mildew.
7. Maintenance
Cleaning the Nozzle
Unplug carpet cleaner from electrical outlet.
Wipe debris off nozzle and front of cleaner with a damp
cloth (Fig.7/1).
Cleaning the Brushes
Unplug carpet cleaner from electrical outlet.
Remove solution and recovery tanks to prevent possible
leaks.
Tilt cleaner back so handle rests on the floor (Fig.7/2).
Remove any carpet fibers or strings that may be attached
to the brushes (Fig.7/3).
Empty solution tank and rinse thoroughly.
Fig.6/5
Fig.7/1
Fig.7/2
Fig.7/3
A
A
Vax V-128 User Guide.qxd:V-128 User Guide 14/4/08 16:01 Page 9
To Next Page
Loading...
Need help?
General
