Getting started
Filling the water tank
With the iron disconnected
from the mains open the
water ll cover.
Tilt the iron forwards.
Using the jug provided ll
the water tank up to the
Max ll line.
Close the water ll cover.
Before you begin
CAUTION: The soleplate becomes very hot during use. Always allow the iron to cool down before carrying out any
maintenance or trouble shooting. Do not use hot or boiling water to ll the water tank. Don’t over ll the water tank
or exceed the maximum amount required. Always unplug from the mains before topping the tank up with water.
Always switch o the iron and allow to cool before emptying the water tank.
IMPORTANT: When using the iron basic safety precautions should always be observed.
Don’t aim the steam jet at people, animals, plants and electrical components or wires. Never touch the steam
jet (there is a risk of scalding).
Before rst use remove labels and all packaging.
Always make sure the water ll cover is closed correctly before use.
NOTE: The iron can be lled with tap water. For hard water areas we recommend the use of distilled
or demineralised water. Half ll the water tank with distilled or demineralised water and top up to the
‘Max’ line with tap water.
Do not add perfume, vinegar, starch, descaling agents, ironing aids or other chemicals to the water tank.
When lling make sure the appliance is unplugged.
To Next Page
Loading...