5
operation
IMPORTANT: Maximum water temperature
40°C.
Fill the clean water tank with clean water (up to 40˚C).
Replace the measuring cap (Fig 4/4).
NOTE: only use Vax carpet cleaning solution. Using
other cleaning solutions may cause excessive
foaming. Using other cleaning solutions will
invalidate your guarantee.
Place the bottom of the clean water tank into the cleaner
and click into place. (Fig 4/5).
Plug the cord into an electrical outlet.
Turn the power switch on (Fig 4/6).
The power switch controls the vacuum motor. Press on
the recline pedal and pull the cleaner back into a reclined
position (Fig 4/7).
IMPORTANT: Never leave the cleaner unattended
with the power on.
NOTE: Vacuum carpets thoroughly with dry
vacuum cleaner before washing.
Whilst pressing solution spray trigger, push carpet cleaner
in a forwards motion. Release trigger and pull unit
backwards in same path to remove dirty water and
solution from the carpet. (Fig 4/8).
Repeat if necessary. Empty when the max fill line on the
dirty water tank is reached.
Fig.4/4
Fig.4/5
Fig.4/7
Fig.4/6
Fig.4/8
To Next Page
Loading...
Need help?
General
