3. Fill remainder of clean water tank with warm
(max 40°C) tap water. Replace cap.
4 Place bottom of clean water tank into carpet
washer and push back until it locks into place.
6. Usage
Plug cord into electrical socket. Turn on the machine
by using the on/off switch located on the side of the
machine.
IMPOR
T
ANT: Never leave unit unattended with
power on. Turn off when emptying and filling
tanks. Do not over-saturate the carpet
1 Step onto handle release pedal to put the
machine into cleaning position (Fig.6/1).
While depressing the solution spray trigger, pull
carpet washer in a backward motion. Release
the trigger and push the unit forward in the
same path to agitate and remove dirty water
and solution from carpet. (For more heavily
soiled ar
eas, repeat if necessary).
IMPORTANT: For best cleaning results use a
steady, moderate, forward and backward motion.
Always work from back to front across the room to
avoid stepping on wet carpet and lowering the pile.
2 When dirty water tank is full lift dirty water tank
latch and remove from base unit using the
handle.
3 Twist dirty water tank outlet cap to the left and
remove, empty, rinse and replace.
Troubleshooting
6
Fig.5/4
Fig.6/1
Fig.6/2
Fig.6/3
Fig.5/3
V-021 User Guide.qxd 5/6/06 4:14 pm Page 7
To Next Page
Loading...
Need help?
General
