vax.com.au 10
Maintenance
(Keep your Vax as good as new)
Removing blockages from the Turbo Tool (VARU1200 model only)
Removing debris from brushbar
If the light continues to ash after resetting, the brushbar may still be blocked. Using a pair of scissors, cut
through any threads or hairs caught around the brushbar. To access brushbar:
Press the brushbar reset button again to ensure the blockage is fully cleared.
IMPORTANT: For your safety, never try to access / replace brush bar drive belt. If problem persists please
call our careline: AU 1300 361 505 / NZ: 0800 800 900.
Press the two side buttons together
and pull apart.
Carefully use scissors to cut
out the blockage.
Realign turbo brush sides and
press together.
To Next Page
Loading...
Need help?
General
