Using your machine
40C
Max
Fill clean water tank
with solution mix.
Tighten cap before
returning tank to unit.
Unwrap power cord
and plug unit in.
Mix required amount
of pre treatment solution
with warm water
(40ml per 1 litre of water)
Operating your Pre Treatment wand (Dual Power Total home only)
Turn the machine on.
Plug the Pre Treatment
wand into the solution
port. Twist lock to secure.
Spray evenly onto
desired areas.
IMPORTANT: Pre-treating your carpet before washing will help to remove stubborn stains.
Do not saturate your carpet. Leave pre-treatment solution to work for 10-15 minutes.
Before setting the machine to wash, ensure the clean water tank is rinsed thoroughly of Pre Treatment solution.
To Next Page
Loading...
Need help?
General
