24 25
Below are the possible error codes and the faults they refer to.
Commercial vehicle Motorhome Basic Description of fault Remedy
(2)
Compressor used too
intensively.
Thermal cutout.
Allow compressor to cool down.
Contact workshop if the fault
keeps coming back.
(2)
Valve block used too
intensively.
Thermal cutout.
Allow valve block to cool down.
Contact workshop if the fault
keeps coming back.
(4)
Maximum permitted load
exceeded.
Reduce load.
(4)
Compressor's maxi-
mum working pressure
reached.
Reduce load.
(5)
Battery voltage too low to
raise the air suspension.
Start the vehicle's engine.
(5)
Battery voltage too low. Charge the vehicle's battery.
In view of the many features and options, your remote control may differ from the example
shown. However, the error codes are the same in all cases.
"If your fault does not appear in the table, contact your conversion station (see page 3)."
Basic remote control
On some vehicles the air suspension system has a 'basic remote control'. This remote control has
three fixed modes: highest position, ride height and lowest position.
Check light
1. Activate manual operation:
The check light comes on for one second:
The system has started correctly.
The check light remains lit:
The vehicle is not at ride height.
The check light keeps flashing:
The system is detecting a fault (see error code for solution).
Switch
1. Activate manual operation:
From highest position, press switch briefly downwards:
Vehicle sets itself to ride height automatically.
From lowest position, press switch briefly upwards:
Vehicle sets itself to ride-height automatically.
From ride height, press switch briefly downwards:
Vehicle sets itself to the lowest position.
From ride height, press switch briefly upwards:
Vehicle sets itself to the highest position.
Error code
If the system detects a fault, the CHECK-LED on the remote control flashes. If you then press the
SERVICE button, a combination of lit and flashing LEDs on the various buttons provides an error
code.
LEDs on the buttons are off
LEDs on the buttons are flashing
LEDs on the buttons are lit
To Next Page
Loading...