“RMF” - RECESSED HIGH
PRESSURE DUCT FANS
Installation Instructions
• for toilets, bathrooms and utility rooms
• suitable for installation in:
- ceiling
- wall
• 4 models:
- standard
- timer
- two speed
- humidity control with two speed
• 2 Low Voltage (SELV) models
- standard
- timer
WIRING INSTRUCTIONS
1. Ensure that the mains electrical supply is switched off during the installation of the fixed wiring spur.
2. Read carefully "Important-Electrical Information" above.
3. Connect as shown in the Wiring Diagrams below.
RMF 100 RMF 100T, RMF100 2R, RMF100 H2R
Fig A
Fig B
Lamp
RMF 100 LV RMF 100TLV
CLEANING & MAINTENANCE
1. Disconnect mains electrical supply by means of double pole switch.
2. Remove front grille as described above.
3. Remove the plastic impeller (by loosening the nut) and wash it with mild detergent.
4. To clean the inner part of the fan, use a soft brush taking care not to cause any damage or disturb the
electrical wiring.
Vectaire Ltd
Lincoln Road,
Cressex Business Park,
High Wycombe, Bucks, HP12 3RH, UK
Tel: +44 (0) 1494 522333 Fax: +44 (0) 1494 522337
To Next Page
Need help?
General
