VECTOR
4 USER'S
MANUAL
VECTOR
4 CP/M RESIDENT
COMMANDS
ERROR - d:ILLEGAL
''l'
IN :rCB
entry
uses
wild:"card
in
file
name
specification; file entered must be ufn.
PRINTER IS
BUSY
printer
is
in
use
by
another program.
If
no
error-causing condition exists, the previously-spooled
file
RECORD.SPL
will be printed out
on
printer 2.
The
KSPL Command
The
KSPL command
will
abort,
or
prematurely
stop,
the
operation
of
the
despooler; otherwise,
the
despooler will
t~m
off
normally
once
the
specified
file has been printed.
FORMAT:
KSPL [RETURN]
EXAMPLE:
A>KSEL [RETURN]
RESULT:
After
the
command is
entered,
one of the following messages will display on
the terminal giving the
status
of the abort attempt:
DESPOOL
ABORTED
despooler
has
been
aborted
successfully.
The
printer will stop.
DESPOOL
NOT
ACTIVE
despooler is not active so cannot be aborted.
NOTE:
The
despooler will
ng1
expand tabs or initialize pagination control;
it
will
send
characters
to
the
prin.ter
exactly
as
they
are
in
the file.
It
is
important
to
spool
to
a file using a printer driver
to
achieve printing
effects.
The
BYB
Command
The
BYE
command
will
allow
you
to
perform a cold boot procedure
at
your
terminal, without having to press the
RESET
button. The command
format
is
the follow ing:
Rev. A - 9"'01-82
7100-0001
vnI-15
To Next Page
Loading...