VECTOR
GRAPmC,
INC.
Other
Functions of
the
STAT
Pr<JgraJD
As
indicated
in
the
STAT VAL:
display,
you can use
the
STAT program for
several
other
things in addition
to
these.
However, most additional
commands
change
input
and
output
devices,
such
as
tape
readers,
batch
processors,
teletypes, paper
tape
punch devices, or non-standard
list
devices.
Enter
STAT
VAL:
[RETURN] for a
list
of
the
valid device names (listed under
IObyte Assign) supported
on
your specific system.
Enter
STAT
DSK: [RETURN]
to
find
out
the
specific
status
and
capacity
of
the
disk, in records, bytes, extents,
et
cetera.
Changing
the
status
of other devices
w.ill
not be covered in this manual, since
it
requires more experience with
the
system.
For
more
information,
see
the
Vector 4 CP/M Programmer's Guide.
Review
The
STAT program
can
be
used as a simple command (STAT [RETURND, which
shows remaining disk space.
It
can
also
be
used with
the
following
command
lines:
TO FIND/CHANGE
Size
of a file
Change file/disk
attributes
IX-26
COMMAND
IJNE
AND
COMMENTS
STAT d:SAMPLE.DOC [RETURN]
(Lists
number
of
virtual
records
per
extent
under
"Recs" column)
STAT
d:SAMPLE.DOC
$S
(Lists virtual file
size
in
records under "Size" column)
STAT
d:<SAMPLE.DOC)
$R/W
(Makes
file
or
disk
available
for
editing
or
other
changes)
STAT
d:<SAMPLE.DOC) $R/O
(Protects
the file or disk from changes)
STAT
d:SAMPLE.DOC
$SYS
(Changes
the
file
to
a
"system"
file,
which does not
appear in
the
directory)
STAT
d:SAMPLE.DOC
$Dm
(Changes
the
file
back
so
that
it
will
appear in
the
directory)
7100-0001
09-01-82
- Rev. A
To Next Page
Loading...