VECTOR
GRAPmC,
INC.
NOTE
You
will notice
that
the sample screen display
gives
two
double-sided
drives
and one single-sided drive.
You
can only copy diskettes:
• from double-sided
to
double-sided
• from single-sided
to
single-sided
You
cannot
copy
from
a double-sided drive
to
a single-sided drive. Remember
also
that
you cannot copy the System diskette
to
a single-sided diskette.
If
you
are
logged into a hard drive with sufficient
free
space,
the
screen will
ask you:
DO YOU
WANT
TO
USE
THE
WINCHESTER AS TEMPORARY STORAGE!
(Y
....
N)
Selecting
Y [RETURN] will save you time. (This prompt will not display
if
you
are
not logged into a hard drive or
if
there is not enough
room
on
the default drive, even
if
your system uses one.)
4.
Once you
have
selected
the
source
and
target
drives, the screen will
display:
INSERT SOURCE DISKETTE AND PRESS [RETURN]
If
you
are
using a Winchester or a two-floppy system, the screen will display
this and the following prompt once only.
If
you
cannot
use
th.e Winchester,
the
screen
will display these two prompts until the source disk has been fully
copied:
INSERT DES11NATION DISKETTE AND PRESS [RETURN]
When
the source diskette has been fully copied,
the
screen will display:
DISKCOPY COMPLETE.
The.
STORR
.command
IX-36
This is
used
to
back
up
files
from a hard disk
to
a floppy. (If your system
only has
floppy drives, you can ignore this section, as well as
the
section
on
RESTORE.)
Note;
the
STORE and
RESTORE
programs will only take files with names of
seven characters
or less. The
STORE
program adds a number
to
the
end of
each
filename when
it
is continued
on
another diskette,
to
indicate whether
it
belongs on disk 0, disk 1, disk 2,
et
cetera.
Since
CP
1M
allows
eight
characters per filename, this
extra
number has to come
from
somewhere.
7100-0001
2-01-83 - Rev. B
To Next Page
Loading...