VEcrOR
GRAPmC,
mc.
CONPIG.COM
This
program
allows
you
to
specify
the
configuration
of
your
system.
Depending
on
the option selected,
it
can be used
to
select
printers,
specify
baud (transmission)
rate
for
printers
and modems, specify page size,
set
up
"~uto-commandslf
for automatic start-up procedures,
specify
different
logical
drives
as
single-
and double-sided, and modify the operating system in several
other ways.
STAT.COM
This program
can
be
used
to
determine statistical information
on
the amount
and type of storage in disks or diskettes.
It
can also be used
to
set
files
or
entire
disks to Read-Only
(RIO)
status, protecting
them
from changes.
It
can
also be used
to
set
them
back to Read-Write (R/W), enabling you ·to change
them.
PIP.COM
This program is used
to
copy fUes (using unambiguous or ambiguous
fUe
names)
from
one disk
or
user
area
to
another.
It
cannot be used
to
copy
files
with
an
extension
of
DBS
(database fUes), or
fUes
which have been
set
to
$SYS
by
the
STAT
command.
STOB.E.COM
This program is used
to
copy
files
from hard disk
to
floppy for backup.,
It
can
only copy
files
with filenames
of
seven
characters
or
less.
It
will
.
continue
files
across more than one diskette,
and
it
will copy database
(DBS)
fUes.
RESTORR.COM
This program is used
to
copy
fUes
back
to
the hard disk, from a floppy where
they were copied using
the
STORE
program.
If
the
STOREd
fUes extend
over
more
than
one
diskette,
it
is
essential
to
RESTORE
them in the order
that
they were copied.
X E-2
7100-0001
9...01-82
- Rev. A
To Next Page
Loading...