Vector 3,000,000 POWER SERIES SPOTLIGHT User Manual

6. Disconnect the bulb wire from the red power wire and set the burned out bulb
aside.
7. Unsnap the hairpin retaining wires from the reflector’s flange (see details 4A and
4B)
8. Using the screwdriver, loosen the retaining screw to remove the bulb from the
reflector (no need to completely remove this screw).
9. Lift out the bulb and the attached wire.
10. Insert the replacement bulb into the reflector’s flange.
11. Put back and secure the hairpin retaining wires.
12. Connect the white bulb power wire to the red power wire.
13. Tighten the retaining screw on the flange.
14. Place the reflector in position in the body of the spotlight.
15. Replace the rubber ring in the groove around the perimeter of the reflector.
16. Replace glass and retainer so that the screw holes are aligned.
Rubber
Bezel
Reflector
Assembly
Retainer
Reflector
Rubber Ring
Glass Lens
Figure 4
Hairpin
Retainer Wires
Figure 4BFigure 4A

Vector 3,000,000 POWER SERIES SPOTLIGHT Specifications

General

Brand	Vector
Model	3, 000, 000 POWER SERIES SPOTLIGHT
Category	Spotlight
Language	English