Vector 4 - Page 163

VECTOR GRAPHIC, INC,
F) BOLDFACE TYPE - If you are having problems with the horizontal
positioning, this is another test you can use. It tests the fine adjustment
of the horizontal positioning. The problems atributed to a faulty
horizontal positioning are usually caused by a carriage motor cable which
is out of adjustment.
G) RETURN TO CP/M - Allows you to go back to CP/M.
To run one of these tests, enter the letter of the test you want to run,
followed by a [RETURNL. If you need to run more than one test, you can
enter all the letters at the same time, and press [RETURNL
On the screen you will see the following legend in reverse video:
- Now Executing : <test name>
This legend will appear whether or not an electronic or mechanical problem
exists. You will know that a fault exists when the printer does not execute
the test(s) that you have chosen.
If a mechanical or electronic failure does occur, it may be caused by the
printer, the cable, or some component of the SBC.
NOTE:
To STOP the test which you are running, enter [ESC} this will abort the test
in process. |
III 4-8 7200-0001 09-01-82