EasyManua.ls Logo

Vector START-IT VEC021ST - Emergency Work Light; Bulb Replacement; Battery Replacement; Battery Disposal Warnings

Vector START-IT VEC021ST
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CAUTION: DO NOT USE THIS UNIT TO OPERATE APPLIANCES THAT DRAW MORE THAN
200 WATTS OR EXCEED MAXIMUM WATTAGE OF INVERTER.
5. EMERGENCY/WORK LIGHT
Bulb Replacement
You will need a small Phillips screwdriver
1.Replacement bulbs are available from Vector
®
Customer Service Department; call (954) 584-4446 EXT. 19 or
toll-free (866) 584-5504
2.Remove two Phillips screws from the lens.
3.Lift off the lens assembly.
4.Remove the burned-out bulb.
5.Replace with a new bulb (12-volt 0.4 amp Krypton bulb).
6.Snap the lens cover back into place, and replace Phillips screws.
6. BATTERY REPLACEMENT
IT IS RECOMMENDED THAT THE UNIT BE RETURNED TO VECTOR
®
CUSTOMER SERVICE FOR BATTERY
REPLACEMENT: CONTACT (954) 584-4446 EXT. 19, OR TOLL-FREE (866) 584-5504
6.1 Battery Disposal
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed of properly. Some
states require recycling – contact your local authority for information.
THIS UNIT CONTAINS A MAINTENANCE-FREE, SEALED, NON-SPILLABLE, LEAD ACID BATTERY
WHICH MUST BE DISPOSED OF PROPERLY. SOME STATES REQUIRE RECYCLING.
DISPOSAL QUESTIONS? IN USA, CALL 1-877-288-7722.
WARNINGS:
DO NOT DISPOSE OF THE BATTERY IN FIRE AS THIS MAY RESULT IN AN EXPLOSION.
BEFORE DISPOSING OF THE BATTERY, PROTECT EXPOSED TERMINALS WITH HEAVY-DUTY
ELECTRICAL TAPE TO PREVENT SHORTING (SHORTING CAN RESULT IN INJURY OR FIRE).
DO NOT EXPOSE BATTERY TO FIRE OR INTENSE HEAT AS IT MAY EXPLODE.
Model ..................................................................................................................................VEC021ST
Voltage ....................................................................................................................................12 VDC
Instantaneous Cranking ......................................................................400 Instantaneous Cranking Amps
Peak Ampere Power ............................................................................................................1000 Amps
Battery Type ...................................................................Non Spillable Sealed, lead- acid, rechargeable,
maintenance-free, 12-volt DC,19 Amp-hour
Bulb................................................................................................................12-volt 0.4 Amp Krypton
Booster Cables....................................................................................... Heavy-Duty welding type cable
................................................................................................................with 400 Amp copper clamps
Accessory Socket Self-Resetting Breaker ....................................................................................20 Amps
DC Charging Cord ...............................................................................................................12-Volt DC
Adapter/Charger .......................................................................................................110/120-Volt AC
.................................................................................................................(800mA, 12-Volt DC Output)
HEIGHT...............................................................................................................11-3/4” (29.845CM)
DEPTH...................................................................................................................6-1/4” (15.875CM)
WIDTH.................................................................................................................11-5/8” (29.528CM)
WEIGHT....................................................................................................................18LBS. (8.164KG)
11

Related product manuals