What to do if Vectrix VX-2 Scooter says 'Stop scooter Battery empty!'?
If your Vectrix Scooter displays 'Stop scooter Battery empty!', it indicates that the battery voltage is permanently below 42V. To resolve this, charge the battery.
What to do if Vectrix Scooter shows 'Error Voltage too high'?
If your Vectrix Scooter displays 'Error Voltage too high', it means the battery voltage exceeds 63V. First, use the scooter carefully until the message disappears. If the problem persists, verify that the actual battery voltage is below 63V and check the controller settings. As a last resort, consider replacing the controller.
What to do if Vectrix Scooter displays 'Error Overcurrent'?
If your Vectrix Scooter shows 'Error Overcurrent', this indicates a controller defect. The suggested solution is to exchange the controller and inspect the motor for short winding against the housing.
What to do if Vectrix Scooter displays 'Error Accelerator Volt'?
If your Vectrix Scooter displays 'Error Accelerator Volt', it means that the accelerator voltage is too high. Try releasing the accelerator or turning the power off and then on again. If that doesn't work, proceed to the Accelerator troubleshooting diagram.
Why does the Vectrix VX-2 accelerator turn at power up?
If the Vectrix Scooter's accelerator turns at power up, it's because the accelerator is not in the zero position. Try releasing the accelerator, or turn the power off and then on again. Alternatively, consult the Accelerator troubleshooting diagram.
General| Category | Scooter |
|---|---|
| Manufacturer | Vectrix |
| Model | VX-2 |
| Motor Type | Electric |
| Battery | Lithium-ion |
| Brakes | Disc brakes |
To Next Page
