Copyright ©2023 Veeniix All Rights Reserved. 32
The Gimbal cannot work during the Compass and Gyroscope
calibration. Put the aircraft on a level surface after calibration,
then the gimbal will start to work after 20 seconds.
Do not interfere with the gimbal by external forces or pick up
the aircraft during self-inspection (After Compass and Gyroscope
calibration, the gimbal will enter self-inspection for 20 seconds).
Picking up the aircraft
(during self-inspection)
Touching the camera
Before power on
During Compass and Gyroscope calibration
Put on a level surface and wait for 20 seconds
④
⑤
To Next Page
Loading...