Wiring
Wiring
Follow the diagram and the steps below for wiring connections.
1. Make connections at the removable terminal strips mounted on the power board.
2. Access the power board by removing the explosion-proof housing cap.
3. Connect the power earth ground wire with the internal and external ground screw.
4. Access the ground screws by removing the top cover.
Interconnecting Terminals – GEN2000 HART
1 Power In (L)
2 Power In (N)
3 Relay Normally Open (NO)
4 Relay Common (C)
5 Relay Normally Closed (NC)
6 Frequency +
7 Frequency -
8 + 6V Auxiliary Input Power (Not used in HART Applications)
9 Common
10 -6V Auxiliary Input Power
11 Auxiliary Input Frequency Signal +
12 Auxiliary Input Frequency Signal -
13 Current Loop Output +
14 Current Loop Output –
7
To Next Page
Loading...
