Vega FIBERTRAC 31 - Saving the parameterisation data

60
6 Set up with the display and adjustment module
FIBERTRAC 31 • Probus PA
43833-EN-170126
•
Instrument version - shows hardware and software version of the
instrument
•
Date of manufacture - shows calibration date and the date of the
last change
•
Probus Ident Number - shows the Probus ident number
•
Instrument features - shows further instrument features, such as
e.g. approval, electronics …
Examples for info display:
6.6 Saving the parameterisation data
We recommended writing down the adjustment data, e.g. in this op-
erating instructions manual, and archiving them afterwards. They are
thus available for multiple use or service purposes.
If the instrument is equipped with a display and adjustment module,
the data in the sensor can be saved in the display and adjustment
module. The procedure is described in menu item "Copy device
settings" in the menu "Additional settings". The data remain there
permanently even if the sensor power supply fails.
The following data or settings for adjustment of the display and ad-
justment module are saved:
•
All data of the menu "Setup" and "Display"
•
The items "Sensor-specicunits,temperatureunitandlinearisa-
tion" in the menu "Additional settings".
•
The values of the user-programmable linearisation curve
The function can also be used to transfer settings from one instru-
ment to another instrument of the same type. If it is necessary to
exchange a sensor, the display and adjustment module is inserted
into the replacement instrument and the data are likewise written into
the sensor via the menu item "Copy device settings".
Backup on paper
Backup in the displa
y and
adjustment module