Instruction Manual PEL-4 Precision LED Sector Light Vega Industries Ltd Aug 2018
PEL-4 Precision LED Sector Light Page 13 of 69 Manual Version V1.06
IMPORTANT
Before attempting to use the TVIR
programmer for the first time, please pull
the plastic insulating strip out of the battery
holder – you do not need to remove the
battery holder to do this.
The TVIR programmer will not work if the
plastic strip is left in place.
4.0 PROGRAMMING
The PEL-4 can be programmed using the TVIR programmer (shown below).
The infrared receiver for programming the PEL-4 is located in the programming and
daylight sensor projecting from the connector face of the PEL-4 mainframe (indicated by
the red markings in the following diagrams). For best results when programming, direct the
TVIR programmer at this part of the PEL-4. Refer to Appendix A for operating the TVIR
Programmer.
Location of the PEL-4 Programming Infrared Receiver and Daylight Detector
Location of the PEL-4 Programming Infrared Receiver and Daylight Detector
Red standby key,
used to enter
Numeric keypad,
used to
configure the
programmable
To Next Page
Loading...
