Vega PEL-4 - Peak Intensity During the Flash Mode

Instruction Manual PEL-4 Precision LED Sector Light Vega Industries Ltd Aug 2018
PEL-4 Precision LED Sector Light Page 26 of 69 Manual Version V1.06
The alternative IALA E-200-4 2008 can be selected as follows:
Operation =Special =7
Feature =Set Flash Mode =2
Value =Select from Appendix A =XY2 (X & Y are independent of this
mode)
X is presently always zero. Y is independent and defines the auxiliary and special flashing
mode as described in the previous section.
8.1.2 Peak Intensity During the Flash Mode
No flash compensation is applied in this mode. The programmed day or night intensity is
directly output from the PEL-4 during the flash on (a.k.a. peak) period of the flash
character.
Peak intensity during flash mode can be selected as follows:
Operation =Special =7
Feature =Set Flash Mode =2
Value =Select from Appendix A =XY1 (X & Y are independent of this
mode)
X is presently always zero. Y is independent and defines the auxiliary and special flashing
mode as described in the previous section.