Instruction Manual PEL-4 Precision LED Sector Light Vega Industries Ltd Aug 2018
PEL-4 Precision LED Sector Light Page 32 of 69 Manual Version V1.06
10.0 ROUTINE MAINTENANCE
10.1 Maintenance Cleaning
Vega PEL-4 requires no internal maintenance.
The exterior of the PEL-4 should be inspected and cleaned occasionally to ensure
maximum intensity and that no foreign material is trapped in the heat sink on the rear of
each unit.
Use warm soapy water to wash the exposed front lens surface and the outside of the PEL-
4. Rinse off with clean water.
Do not use any form of abrasive cloth or cleaner on any part of the PEL.
Regular opening of the PEL-4’s rear cover is not recommended. There are no user-
serviceable parts inside.
Do not touch, rub or clean the LED. The LED can be hot and extremely bright.
Do not touch, rub or clean the filters.
It is not recommended to clean the acrylic condenser lens. If necessary, a lint-free cloth,
preferably an anti-static type could be used to gently clean both surfaces of the acrylic
condenser lens. Be careful not to touch the LED or the filters while cleaning the acrylic
condenser lens. Do not use any form of abrasive cloth or cleaner on the lens.
Keep the inside of the PEL-4 dry at all times.
There is no requirement for replacement of lubricant.
10.2 Inspection check
Periodically check that the PEL-4 remains firmly secured and level, and that the mounting
fasteners are still in good condition. Investigate any corrosion of the mounting structure
and take appropriate preventive action.
To Next Page
Loading...
