Instruction Manual PEL-4 Precision LED Sector Light Vega Industries Ltd Aug 2018
PEL-4 Precision LED Sector Light Page 33 of 69 Manual Version V1.06
APPENDIX A PROGRAMMING TABLE
Appendix A.1 Generic TVIR Programming Commands
PEL-4s are shipped in Normal, Automatic and Single Character Mode unless specifically
requested otherwise. The operating mode and other settings are indicated on the
associated PEL-4 test sheet.
The operator has full control of the PEL-4’s operational mode and all settings can be
altered as described in the following tables.
For most TVIR commands in the following table, the corresponding serial interface
command or related serial commands are shown in
Courier New
font. All serial interface
commands can accept a question mark, ‘?’ as a parameter and will return the current
settings after the receipt of the trailing forward slash ‘/’. (Parameter ‘
B
’ in various
commands represents a binary value, ‘0’ or ‘1’.) Most commands require a PEL-4 restart
(‘
<RST>1/
’) before they will affect PEL-4 operation.
To Next Page
Loading...
