Instruction Manual PEL-4 Precision LED Sector Light Vega Industries Ltd Aug 2018
PEL-4 Precision LED Sector Light Page 41 of 69 Manual Version V1.06
Appendix A.2 Remote Control Input Level Settings
The following table describes the four combinatorial options for remote control of the PEL-
4. There are two separate remote control inputs: On/Off and Day/Night. Each control input
is either enabled (shown with a symbol) or disabled (shown with ‘Auto’). When a control
input is enabled then its equivalent serial interface command is also enabled.
PEL
PELPEL
PEL-
--
-4
44
4
Remote Control I/O Settings
Remote Control I/O SettingsRemote Control I/O Settings
Remote Control I/O Settings
Programming
Programming Programming
Programming
Code /
Code /Code /
Code /
Serial
Serial Serial
Serial
Command
CommandCommand
Command
Input’s
Input’s Input’s
Input’s
Active
Active Active
Active
Level
LevelLevel
Level
(X
(X(X
(X=1
=1=1
=1)
))
)
Internal
Internal Internal
Internal
Pull
PullPull
Pull-
--
-up or
up or up or
up or
Pull
PullPull
Pull-
--
-down
downdown
down
(Y=1)
(Y=1)(Y=1)
(Y=1)
Enabled Inputs (Z)
Enabled Inputs (Z)Enabled Inputs (Z)
Enabled Inputs (Z)
Type of Inputs
Type of Inputs Type of Inputs
Type of Inputs
and
and and
and
Operational State
Operational StateOperational State
Operational State
(Active states are
(Active states are (Active states are
(Active states are
On & Day)
On & Day)On & Day)
On & Day)
On/
On/On/
On/
Off
OffOff
Off
(val 4)
Day/
Day/Day/
Day/
Night
NightNight
Night
(val 2)
7-4-110
<RCM>110/
High
Active
(>4V)
(Open
circuit is
inactive)
Pull-
down
Auto Auto Normal Automatic
(Best Effort)
operation. All inputs
inactive. All serial
control commands
7-4-112
<RCM>112/
Auto
PEL-4 automatically
operational. <RDN>
serial command is
7-4-114
<RCM>114/
Auto On/Off input is
operational. <RON>
serial command is
operational. Day/Night
operations are
automatic.
7-4-116
<RCM>116/
On/Off and Day/Night
inputs operational.
<RON> and <RDN>
serial commands are
operational.
To Next Page
Loading...
