Vega VEGAFLEX 81 - Mounting; 4.1 General instructions

14
4 Mounting
VEGAFLEX 81 • Modbus and Levelmaster protocol
42283-EN-140430
4 Mounting
4.1 General instructions
Oninstrumentswithprocessttingthread,thehexagonmustbetight-
enedwithasuitablescrewdriver.Wrenchsizeseechapter"Dimen-
sions".
Warning:
The housing must not be used to screw the instrument in! Applying
tightening force can damage internal parts of the housing.
Protect your instrument against moisture penetration through the fol-
lowing measures:
•
Use the recommended cable (see chapter "Connectingtopower
supply")
•
Tighten the cable gland
•
Turn the housing in such a way that the cable gland points down-
ward
•
Loop the connection cable downward in front of the cable gland
This applies particularly to:
•
Outdoor mounting
•
Installations in areas where high humidity is expected (e.g. through
cleaning processes)
•
Installations on cooled or heated vessels
In the case of instrument housings with self-sealing NPT threads, it is
not possible to have the cable entries screwed in at the factory. The
openings for the cable glands are therefore covered with red protec-
tive caps as transport protection.
Prior to setup you have to replace these protective caps with ap-
proved cable glands or close the openings with suitable blind plugs.
The suitable cable glands and blind plugs come with the instrument.
Make sure that all parts of the instrument exposed to the process are
suitable for the existing process conditions.
These are mainly:
•
Active measuring component
•
Processtting
•
Process seal
Process conditions are particularly:
•
Process pressure
•
Process temperature
•
Chemical properties of the medium
•
Abrasionandmechanicalinuences
Youcanndthespecicationsoftheprocessconditionsinchapter
"Technicaldata" as well as on the type label.
Screwing in
Protection against mois-
ture
Protective caps
Suitability for the process
conditions