Vega VEGAFLEX 81 - 6.4 Parameter adjustment - Quick setup; Medium - dielectric constant; Max. adjustment

27
6 Set up the sensor with the display and adjustment module
VEGAFLEX 81 • Modbus and Levelmaster protocol
42283-EN-140430
•
Device name
•
Software version (SW-Ver)
•
Hardware version (HW-Ver)
With the [->]keyyoucanmovebetweenthreedierentindication
modes.
Intherstview,theselectedmeasuredvalueisdisplayedinlarge
digits.
In the second view, the selected measured value and a correspond-
ing bar graph presentation are displayed.
In the third view, the selected measured value as well as a second
selectable value, e.g. the temperature, are displayed.
6.4 Parameter adjustment - Quick setup
To quickly and easily adapt the sensor to the application, select
the menu item "Quick setup" in the start graphic on the display and
adjustment module.
Youcannd"Extendedadjustment"inthenextsub-chapter.
Measurement loop name
Intherstmenuitemyoucanassignasuitablemeasurementloop
name. You can enter a name with max. 19 characters.
Type of medium
In the next menu item you can see which type of medium the instru-
ment is suitable for. If your instrument is only suitable for a certain
medium, this menu item is not visible.
Application
In this menu item, you can select the application. You can choose
between level measurement and interface measurement. You can
also choose between measurement in a vessel or in a bypass or
standpipe.
Medium - dielectric constant
Inthismenuitem,youcandenethetypeofmedium(product).
Max. adjustment
In this menu item, you can enter the max. adjustment for the level.
Measured value indica-
tion
Quick setup
General information
Level measurement