Vega VEGAFLEX 86 - Wiring plan - version IP 66;IP 68, 1 bar; Supplementary electronics; Set instrument address

31
5 Connecting to power supply
VEGAFLEX 86 • Probus PA
44232-EN-160518
5.6 Wiring plan - version IP 66/IP 68, 1 bar
1
2
Fig. 22: Wire assignment in permanently connected connection cable
1 brown (+) and blue (-) to power supply or to the processing system
2 Shielding
5.7 Supplementary electronics
The radio module PLICSMOBILE is an external GSM/GPRS radio
unit for transmission of measured values and for remote parameter
adjustment.
1
USB
Status
Te st
SIM-Card
1
2
+
( )
(-)
Fig.23:RadiomodulePLICSMOBILEintegratedintheconnectioncompart-
ment
1 Voltage supply
You can nd detailed information on connection in the supplementary
instructions "PLICSMOBILEGSM/GPRSradiomodule".
5.8 Set instrument address
An address must be assigned to each Probus PA instrument. The
approved addresses are between 0 and 126. Each address must
only be assigned once in the Probus PA network. The sensor is only
recognized by the control system if the address is set correctly.
When the instrument is shipped, address 126 is set. This address can
be used to test the function of the instrument and to connect it to a
Probus PA network. Then the address must be changed to integrate
additional instruments.
The address setting is carried out either via:
•
The address selection switch in the electronics compartment of
the instrument (address setting via hardware)
•
The display and adjustment module (address setting via software)
•
PACTware/DTM (address setting via software)
Wire assignment, con-
nection cable
Supplementary elec-
tronics - R
adio module
PLICSMOBILE
Instrument address