Vega VEGAFLEX 86 - Saving the parameter adjustment data

54
6 Set up with the display and adjustment module
VEGAFLEX 86 • Probus PA
44232-EN-160518
In this menu item, the date of factory calibration of the sensor as well
as the date of the last change of sensor parameters are displayed via
the display and adjustment module or via the PC.
In this menu item, the Probus ident number of your sensor is dis-
played.
In this menu item, the features of the sensor such as approval, pro-
cess tting, seal, measuring range, electronics, housing and others
are displayed.
6.5 Saving the parameter adjustment data
We recommended noting the adjusted data, e.g. in this operating
instructions manual, and archiving them afterwards. They are thus
available for multiple use or service purposes.
If the instrument is equipped with a display and adjustment module,
the data in the sensor can be saved in the display and adjustment
module. The procedure is described in the menu "Additional adjust-
ments" in the menu item "
Copysensordata". The data remain there
permanently even if the sensor power supply fails.
The following data or settings for adjustment of the display and ad-
justment module are saved:
•
All data of the menu "Setup" and "Display"
•
In the menu "Additional settings" the items "Sensor-specicunits,
temperature unit and linearization"
•
The values of the user programmable linearization curve
The function can also be used to transfer settings from one instru-
ment to another instrument of the same type. If it is necessary to
exchange a sensor, the display and adjustment module is inserted
into the replacement instrument and the data are likewise written into
the sensor via the menu item "
Copysensordata".
Info - Factory calibration
date
Info-ProbusIdent
Number
Info - Sensor character-
istics
Backup on paper
Backup in the display and
adjustment module