EasyManua.ls Logo

Vega VEGAMET 624 - 11 Measured Value Transmission Via SMS; General Information; Settings For Sms Transmission

Vega VEGAMET 624
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
57
11MeasuredvaluetransmissionviaSMS
RS232/Ethernet connection • VEGAMET 391/624/625, VEGASCAN 693, PLICSRADIO C62
30325-EN-130701
11 Measured value transmission via SMS
11.1 General information
SendinganSMSisonlypossiblewithsignalconditioninginstruments
withserialinterfaceinconjunctionwithmodemssupportedbyVEGA.
AGSMmodemandaconventionaltelephonenetworkmodemare
availablefortheanaloguetelephoneconnection.To sendanSMS,
thesignalconditioninginstrumentdialsintoanSMSServiceCenter
(SMSC):ViathisSMSServiceCentertheSMSisthetransferredto
thesubscriber(e.g.mobilephone).
Note:
TosetuptheSMSfunction,PACTwar ewiththecorrespondingDTMs
is required.
11.2 Settings for SMS transmission
OpenthesuitableDTMinPACTware andselectthemenuitem
"Device settings - SMS"forcongurationoftheSMSfunction.As
basicsetting,theconnectedmodemandtherequestedSMSprovider
(SMSC)areselected.
IftheSMSshouldbetransmittedviatheconventionaltelecommuni-
cationnetwork,youwillneedananaloguetelephoneconnectionwith
directoutwarddialingandthePhoenixContactPSIdata/faxmodem
(orderno.:MODEM.JX)
IftransmissionismadeviaGSM,theSiemensTC35iGSMcellular
phonemodemmustbeused(orderno.:MODEM.FX).Forthisyou
willneedaGSMcontract.Makesurethatthereissucientnetwork
coveragebytheprovider.FurthermorethePINoftheusedSIMcard
mustbedeactivated.
Fromtheprovidedlist
youcanselectthesuitableprovider(SMSC).If
therequestedproviderisnotlisted,youcanselect"User-dened"and
entertherespectivephonenumber(onlySiemensTC35i)intheeld
"SMSC phone number".WithPoenixContactPSIData/FaxModem
youcanonlyusetheprovidersavailableinthelist.
Inthiseld,thephonenumberoftheproviderselectedpreviously
fromthelistappears.Afterhavingselected"User-dened"youcan
enter the phone number of the requested provider.
FurtherSMSsettingsarecarriedoutunderthemenuitem"Event list".
Theseare:
"Phone number:"PhonenumberoftheSMSaddressee
"Event type:"Time,measuredvalueorstatus-controlled
"Contents of messages:"Measuredvalueorstatus
"Actuator for transmission:"Time,interval,exceeding/underrun-
ningthemeasuredvalue
Modem
Provider
SMSC phone number
SMScongurationas-
sistent

Other manuals for Vega VEGAMET 624