EasyManua.ls Logo

Vega VEGAMET 624 - 12 Device Trend;Data Logger (Only VEGAMET;VEGASCAN)

Vega VEGAMET 624
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
59
12Devicetrend/Datalogger(onlyVEGAMET/VEGASCAN)
RS232/Ethernet connection • VEGAMET 391/624/625, VEGASCAN 693, PLICSRADIO C62
30325-EN-130701
12 Device trend/Data logger (only VEGAMET/
VEGASCAN)
12.1 General information
WiththedevicerecordingthemeasuredvaluesofaVEGAinstrument
canbemonitored.Therearetwooptionsfortrendrecording:
ThedataaresavedoveracertainperiodintheVEGAinstrument
andcanbereadoutagainlateron.ViaPACTwa re andDTMdierent
recordingconditionscanbesetandtheprocesscanbestartedor
stopped.Themax.recordingperiodislimitedbythememoryofthe
signalconditioninginstrument.Themax.recordingperioddiersde-
pendingontherecordingtype(intervalormeasuredvaluedierence).
Whenrecordingwithinterval,amaximumof200000measuredval-
uescanberecorded,whenrecordingwithmeasuredvaluedierence,
themaximumisreducedto140000.Ifameasuredvalueissaved
everyminute,aperiodofe.g.138daysresults(withmeasuredvalue
dierence).Ifmorethanonecurveisrecorded,thisperiodisreduced
accordingly.
Note:
Therecordeddataarewritteninaperiodoftwotoveminutesfrom
theinternalRAMtoaashdisk.Incaseofvoltagefailure,recordings
ofthelastminutescangetlost.
ThedataareonlysavedonthePCduringanonlineconnectionwith
PACTware andDTM.Themax.recordingperiodislimitedonlybythe
storagespaceontheharddisc.
12.2 Setting of the device trend
ThesettingsarecarriedoutintheDTMunderthemenuitem"Diag-
nostics - Device trend - Settings".Dependingonthedevice,upto15
curvesareavailable(3xwithVEGAMETor15xwithVEGASCAN).If
required,thesecurvesareactivatedordeactivated/deletedonthis
side.Bypushingthebutton"Add",aninstallationassistantforcreating
theselectedcurveisstarted.Thefollowingsettingsarecarriedout
step-by-step:
Intherststepyouhavetoselecttherequestedmeasurementloop
andthemeasuredvalue.
Hereyousettherequestedrecordinginterval.Thefollowingoptions
arepossible:
"In time interval":Recordingiscarriedoutincertainadjustable
timeintervals
"With measured value dierence":Recordingiscarriedoutmeas-
uredvaluedependentwithadjustablemeasuredvaluedierence
Acombinationofthetworecordingmodesisalsopossible.
Device trend
DTM trend
Measurement loop/Meas-
ured value
Recording mode

Other manuals for Vega VEGAMET 624