The measured value indication displays the digital indication value, the
measurement loop designation (measurement loop TAG) and the unit.
An analogue bar graph can also be displayed. By pushing the [>] key,
you move between the individual display options.
32.6
%
TAG-No.1
■
à By pushing [OK] you move from the measured value indication to
the main menu.
▶
Device settings
Measurement loop
Display
Diagnostics
Service
Info
à Select the menu item "Device settings" with [->] and confirm with
[OK].
You can assign an unambiguous name to VEGAMET 624 via the
Device-TAG. This function is recommended when several instruments
are implemented and a good documentation of larger systems is
required.
Device-TAG
Device Name
à Enter the requested values via the appropriate keys and save your
settings with [OK].
For instruments with Ethernet interface, the instrument must be
provided with an IP address/Subnet mask suitable for your network.
Depending on the network, the adjustment of a gateway address is
also necessary. A s an alternative, addressing via DHCP and a host
name is also possible. These specifications are available from your
network administrator. Keep in mind that your settings are only
effective after a restart of VEGAMET 624. Further information to these
network parameters is available in the supplementary instructions
manual "RS232/Ethernet connection" and in the online help of the
corresponding DTMs.
Measured value indica-
tion/Main menu
Device settings - Device-
TAG
Device settings - Host
Name/IP addr.
18 VEGAMET 624 • 4 … 20 mA/HART signal conditioning instrument
6 Setup with the integrated indicating and adjustment unit
28969-EN-091116
To Next Page
Loading...
