Vega VEGAMET 624 - Output configuration

Meas. loop - Meas. loop TAG
Device settings
▶ Measurement loop
Display
Diagnostics
Service
Info
Input
Operation
Damping
Linearisation curve
Scaling
▶ Meas. loop TAG
Measurement loop TAG 1
TAG-No. 1
Meas. loop - Output - Relay
Device settings
▶ Measurement loop
Display
Diagnostics
Service
Info
Operation
Damping
Linearisation curve
Scaling
Meas. loop TAG
▶ Outputs
Outputs ①
▶ Relay outputs
Current outputs
Relay outputs ①
▶ Relay 1
Relay 2
Relay 3
Relay operating mode 1
Overfill protection
▼
Basic meas. value rel. 1
Percent ▼
Rel. switching points 1
Switching point OFF:
100 %
Switching point ON:
0 %
Relay failure mode 1
Switching status:
OFF
▼
Meas. loop - Outputs - Current outputs
Device settings
▶ Measurement loop
Display
Diagnostics
Service
Info
Operation
Damping
Linearisation curve
Scaling
Meas. loop TAG
▶ Outputs
Outputs ①
Relay outputs
▶ Current outputs
Current outputs ①
▶ Current output 1
Current output 2
Current output 3
Current output 1
Basic meas. value: %
▼
Output mode: 4-20 mA ▼
Failure mode: 0 mA ▼
28 VEGAMET 624 • 4 … 20 mA/HART signal conditioning instrument
6 Setup with the integrated indicating and adjustment unit
28969-EN-091116