Vega VEGAMET 861 - Wiring plan

17
5 Connecting to power supply
VEGAMET 861 • 4 … 20 mA/HART
58866-EN-200401
Information:
Solidcoresaswellasexiblecoreswithwireendsleevesare
inserteddirectlyintotheterminalopenings.Incaseofexiblecores
without end sleeves, a small screwdriver must be pressed into the
rectangular opening so that the terminal opening is then free. When
the screwdriver is pulled out, the terminals are closed again.
Youcanndfurtherinformationonthemax.wirecross-sectioninthe
technical data.
Connect the device as described in the following wiring plan.
5.5 Wiring plan
12
1
212223
91 92
LN
+- +-
61 62 63 64 65 66 67 68 69 70 71 72 41 42 123
24 2526
Power
432
1S
ensor 1
Relay Output
Output
Current
Digital IN
5
1 2 3
6 7
8
4
Fig. 6: Wiring plan VEGAMET 861
1 Voltage supply of the controller
2 Relay outputs 1 … 4
3 Current output
4 Sensor input (active/passive)
5 Digital inputs 1/2
6 Ground terminal for protective conductor
7 Ground terminal for cable screening sensor cable
8 Ground terminal for potential equalization
Connecting