Vega VEGAPULS 31 - PC Setup via Bluetooth; PC System Requirements for Bluetooth; Connecting PC via Bluetooth

38
9 Setup with PC/notebook (Bluetooth)
VEGAPULS 31 • Two-wire 4 … 20 mA/HART
57820-EN-191014
9 Setup with PC/notebook (Bluetooth)
9.1 Preparations
Make sure that your PC/notebook meets the following system require-
ments:
•
Operating system Windows 10
•
DTM Collection 12/2019 or newer
•
Bluetooth 4.0 LE or newer
Activate the Bluetooth connection via the VEGA project assistant.
Note:
Older systems do not always have an integrated Bluetooth LE. In
these cases, a Bluetooth USB adapter is required.
Activate the Bluetooth USB adapter via the VEGA project assistant
(see supplementary instructions "Bluetooth USB adapter").
After activating the integrated Bluetooth or the Bluetooth USB adapt-
er, devices with Bluetooth are found and created in the project tree.
9.2 Connecting
Select the requested sensor for the online parameter adjustment in
the project tree.
The window "Authentication
"isdisplayed.Fortherstconnection,
the operating device and the sensor must authenticate each other.
After successful authentication, the next connection functions without
authentication.
For authentication, enter in the next menu window the 6-digit
Bluetooth access code:
Fig. 25: Enter Bluetooth access code
Youcanndthecodeontheoutsideofthedevicehousingandonthe
information sheet "PINs and Codes" in the device packaging.
System requirements
Activate Bluetooth con
-
nection
Connecting …
Authenticate
Enter Bluetooth access
code