Vega VEGAPULS 67 - Page 8

8
3 Mounting
VEGAPULS 67 • HART and accumulator pack
47154-EN-210621
Fig. 3: Radar sensor with mounting strap
The strap is supplied unassembled and must be screwed to the
sensorbeforesetupwiththreehexagonsocketscrewsM5x10and
springwashers.Max.torque,seechapter"Technical data". Required
tools:Allenwrenchsize4.
There are two ways to screw the strap onto the sensor. Depending
ontheselectedversion,thesensorscanbeswivelledinthestrapas
follows:
•
Single chamber housing
– Angleofinclination180°,innitelyvariable
– Angleofinclinationinthreesteps0°,90°and180°
•
Double chamber housing
– Angleofinclination90°,innitelyvariable
– Angle of inclination in two steps 0° and 90°
Fig. 4: Adjustment of the angle of inclination