Vega VEGAPULS 68 - Sensor orientation

24
4 Mounting
VEGAPULS 68 • Foundation Fieldbus
36538-EN-170405
requiredminimumdistance,especiallywithpoorlyreectingmedia
such as plastic powder. In practice, a cleanly constructed mounting
socket, if necessary with rounded edges, introduces fewer disturbing
inuencesthananantennaextension.
To measure as much of the vessel volume as possible, the sensor
should be aligned so that the measuring beam reaches the lowest
level in the vessel. In a cylindrical silo with conical outlet mounting is
carried out on a socket. It should be positioned on one third up to the
half of the vessel radius.
r
rr...
/
1
3
/
1
2
Fig. 14: Orientation
If mounting in the centre of the silo is not possible, the sensor can be
directed to the vessel center by using the optional swivelling holder.
The following description shows a simple way to determine the
required angle of inclination.
Sensor orientation