Vega VEGAPULS 6X - Measured value indication - Selection of national language

60
9 Set up with the display and adjustment module
VEGAPULS 6X • Two-wire 4 … 20 mA/HART
66190-EN-221107
•
[ESC] key:
– Interrupt input
– Jump to next higher menu
The instrument is operated via the four keys of the display and
adjustment module. The individual menu items are shown on the LC
display.Youcanndthefunctionoftheindividualkeysintheprevious
illustration.
When the [+] and [->] keys are pressed quickly, the edited value,
or the cursor, changes one value or position at a time. If the key is
pressed longer than 1 s, the value or position changes continuously.
When the [OK] and [ESC] keys are pressed simultaneously for more
than 5 s, the display returns to the main menu. The menu language is
then switched over to " English".
Approx. 60 minutes after the last pressing of a key, an automatic reset
tomeasuredvalueindicationistriggered.Anyvaluesnotconrmed
with [OK] will not be saved.
9.3 Measured value indication - Selection of
national language
With the [->]keyyoumovebetweenthreedierentindicationmodes:
With the " OK" key you move to the menu overview.
Note:
Duringtherstsetup,youmovewiththe"OK" key to the selection
menu " Menu language".
In this menu item, you can select the menu language for further
parameterization.
Information:
A later change of the selection is possible via the menu item " Setup,
display, menu language".
With the " OK" key you move to the menu overview.
Adjustment system
Time functions
Measured value indica-
tion
Menu language