Velcon/FlexWeigh Model 5 - Page 2

Table of Contents
1.0 General Description ...........................................................................
2.0 Display and Controls..........................................................................
2.1 Display...............................................................................................
2.2 Status Indicators ................................................................................
2.3 Keypad...............................................................................................
3.0 Setup ....................................................................................................
3.1 Power Connection .............................................................................
3.2 Load Cell Connection........................................................................
3.3 Configuration Programming..............................................................
3.4 Set Up Keypad Definitions................................................................
3.5 Program Steps...................................................................................
F1.0 RAW COUNTS DISPLAY.................................................................................
F1.1
FILTER SETTING ..........................................................................................
F1.2
DISPLAY UPDATE RATE................................................................................
F1.3
MOTION WIDTH in DIGITS ...........................................................................
F1.4
AUTO ZERO TRACKING ENABLE ..................................................................
F1.5
AUTO ZERO TRACKING WIDTH ....................................................................
F1.6
2% ZERO RANGE..........................................................................................
F1.7
DISPLAY BRIGHTNESS..................................................................................
F2.0
TARE ENABLE ..............................................................................................
F2.1
TARE INTERLOCK ........................................................................................
F2.2
AUTO CLEAR TARE.......................................................................................
F3.0
BAUD RATE SELECTION...............................................................................
F3.1
PARITY.........................................................................................................
F3.2
PARITY, BITS per CHARACTER, and STOP BITS ...............................................
F3.3
DELAY AFTER CARRIAGE RETURN ...............................................................
F3.4
NEGATIVE PRINT ENABLE............................................................................
F3.5
CHECKSUM TRANSMIT ENABLE...................................................................
F3.6
CTS ENABLE ................................................................................................
F4.0
PRINT MODE ...............................................................................................
F4.1
CONTINUOUS DATA FORMAT.......................................................................
F4.2
WEIGHT CHANGE PERCENTAGE ..................................................................
F4.3
MINIMUM PRINT..........................................................................................