32
33
Owner’s Manual
1. Activate the console by pressing on the ON button for 3 seconds.
2. Press both the «+» and «-» button at the same time for 3 seconds and the
odometer will be set back to zero.
It is the only programmable function. To make sure that the electric bicycle
functions properly, It will be impossible to make any other modifications.
The smart charger supplied with the Velec Citi + allows very fast charging. It
charges the battery at a speed of 4A. This charges approximately 85% of the
batteries in 90 minutes. The remaining 15% will be charged at a slower speed
to increase battery life.
When the charger glows red, the battery is charging. If the indicator light is
green, the battery is fully charged.
HOW TO PUT THE ODOMETER BACK TO
ZERO?
INFORMATION ABOUT THE CHARGER
Press the Thumb Throttle (on the left of the hand-
lebar) until the desired speed is attained, maintain
this speed for a few seconds then press (-) button
until you see a « C » in the LCD panel then you can
release the button the Cruise control is activate. You
can now release the Throttle Handle and the speed
will be maintained.
To deactivate the Cruise Control, simply press one
of the brake levers.
MANUAL MODE WITHOUT
PEDAL-ASSISTANCE OR THROTTLE
When you select the 0 mode from the LCD Panel, the Assistance and the
Throttle will not be active, but you will have access to the Panel informa-
tions, speed, distance, etc.
Note that as soon as you use the brakes, the motor turns off automatically and
the chosen functions are deactivated.
Cruise Control
CRUISE CONTROL
To Next Page
Loading...
Need help?
General