40
41
Owner’s Manual
1. Activate the console by pressing on the ON button for 3 seconds.
2. Press both the «+» and «-» button at the same time for 3 seconds and the
odometer will be set back to zero.
It is the only programmable function. To make sure that the electric bicycle
functions properly, It will be impossible to make any other modifications.
HOW TO PUT THE ODOMETER BACK TO
ZERO?
Press the Thumb Throttle (on the handlebar) until
the desired speed is attained, maintain this speed
for a few seconds then press (-) button until you see
a « C » in the LCD panel then you can release the
button the Cruise control is activate. You can now
release the Throttle Handle and the speed will be
maintained.
To deactivate the Cruise Control, simply press one
of the brake levers.
MANUAL MODE WITHOUT
PEDAL-ASSISTANCE OR THROTTLE
When you select the 0 mode from the LCD Panel, the Assistance and the
Throttle will not be active, but you will have access to the Panel informa-
tions, speed, distance, etc.
Note that as soon as you use the brakes, the motor turns off automatically and
the chosen functions are deactivated.
Cruise Control
CRUISE CONTROL
The smart charger supplied with the Velec Citi + allows very fast charging. It
charges the battery at a speed of 4A. This charges approximately 85% of the
batteries in 90 minutes. The remaining 15% will be charged at a slower speed
to increase battery life.
When the charger glows red, the battery is charging. If the indicator light is
green, the battery is fully charged.
INFORMATION ABOUT THE CHARGER
To Next Page
Loading...